Installation

ASSEMBLING &
INSTALLATION INSTRUCTIONS PRODUCT# 4256 4251 4254
For mini Pendant Fixture
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
ASSEMBLING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker box. Remove old fixture and
all hardware from Junction Box.
2. Carefully unpack your new fixture and lay out all the parts on a clear
area. Take care not to lose any small parts necessary for installation.
3. Thread pipe (D) onto the swivel bottom of canopy (B), thread tube
(E) and (F) onto nipple in order. Then thread them onto nipple with
the socket assemble (G).
5.
Raise the glass shade (H) to bottom of the socket(G),lock it securely
with
ring (I) until sung.
6. Thread the two studs (A) into the pre-drilled holes in the Mounting
strap spaced the same distance apart as the holes in the canopy (B).
7. Attach the Mounting strap to the Junction Box with the two Junction
Box Screws as shown. The side of the Mounting strap marked "GND"
must face out.
8. While holding the column assembly towards the ceiling , connect the
electrical wires as Shown in Fig.2, making sure that all wire nuts are
secured. You may have to wrap the connections with electrical tape.
If your outlet has a ground wire (green or bare copper), connect the
fixture ground wire to it. Otherwise connect fixture’s ground wire
directly to the Mounting strap with the green screw provided. After
wires are connected, tuck them carefully inside the Junction Box.
9. Put canopy (B) on to the outlet box, aligning screws on mounting
strap with mounting holes in canopy and lock it securely with ball
nut (C).
10. Install the light bulbs in accordance with the fixture’s specifications.
NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE.
Your installation is now complete Return power to the
junction box and test the fixture.
Fig.1
Fig.2
White or
HOUSE
Black
WIRES
(Hot)
Smooth
FIXTURE
WIRES
Black or
Ribbed
WIRES
FIXTURE
Bare Copper(Ground)
FIXTURE
WIRES
Copper
(Ground)
HOUSE
(Neutral)
WIRES
White
Bare
Green or
WIRES
HOUSE