Installation Sheet

ManualsBrandsLivex Lighting ManualsChandeliersAstoria 8 Light 1 Tier Linear Chandelier

ASSEMBLING & INSTALLATION INSTRUCTIONS

The drawing shown may not exactly match the product enclosed.

However, the installation instructions do apply to this product.

1328

 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.

ASSEMBLING THE FIXTURE (Fig.1)

1. Shut off the power at the circuit breaker box. Remove old fixture and all

hardware from Junction Box. Carefully unpack your new fixture and lay out all

the parts on a clear area. Take care not to lose any small parts necessary for

installation.

2. Slide the electrical wires through the pipe(K)/(J)/(I) and canopy(F). Raise the

pipe(K) to top pipe thread of lamp body(O), by turning it clockwise until tight.

Raise the pipe(J)/(I) onto the end of pipe(K), by turning it clockwise until

tight.

3. Open link(H) hooked the small loop of canopy(F) and pipe(I), then close the

open link(H).

4. End of pipe thread screw(C) into single bar (D), place lock washer (B) over

end of thread protruding through single bar and lock it securely with the hex

nut (A). Take this single bar assembly to junction box with junction box screws

(E), tighten screws securely with screwdriver. The side of the single bar

marked "GND" must face to out. The junction box is not included.

5. While holding the fixture body towards the ceiling, connect the electrical wires

as Shown in Fig.2, making sure that all wire nuts are secured. You may have

to wrap the connections with electrical tape. If your outlet has a ground wire

(green or bare copper), connect the fixture ground wire to it. Otherwise

connect fixture’s ground wire directly to the Single bar with the green screw

provided. After wires are connected, tuck them carefully inside the Junction

Box.

6. Raise the fixture body onto the Junction box, aligning screw on single bar with

mounting hole in canopy and lock it securely with the finial(G). Raise the

glass(N) and collar ring (M) to the lamp holder, lock it securely with the check

ring(L).

7. Install the light bulbs(Not included) in accordance with the fixture’s

specifications. NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE!

Your installation is now complete. Return power to the junction box and test

the fixture.

FIXTURE

WIRES

Black or

Smooth

HOUSE

WIRES

Black(Hot)

FIXTURE

WIRES

White or

Ribbed

FIXTURE

WIRES

Bare

Copper

(Ground)

HOUSE

WIRES

White

(Neutral)

HOUSE

WIRES

Green or Bare

Copper(Ground)

Thank you for purchasing a LIVEX product.

Need assistance with parts or assembly? Please call customer service at: 800-761-8056

Or visit us online at: WWW.LIVEXLIGHTING.COM

FIG.2

FIG.1