Installation Guide

ASSEMBLING &
INSTALLATION INSTRUCTIONS PRODUCT# 1071
For Wall Mount Fixture
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
MOUNTING THE FIXTURE
Installation (see fig.1)
1. Shut off the power at the circuit breaker and remove old fixture,
including the single bar.
2. Thread the pipe screw part way into the center hole of the single
bar and secure with hex nut.
3. Attach the single bar to the junction box using two box screws.
The side of the single bar marked “GND” must face out.
4. Follow wiring instructions carefully (see fig.2)
5. Place the lamp body(A) over the nipple then tighten it with the
ball nut (D).
6. Attach the glass shade(C) onto the lamp socket(E), then using
the ring (B) by turning it clockwise until tight .
7. Install the light bulbs in accordance with the fixture’s
specifications. DO NOT EXCEED THE MAXIMUM
WATTAGE RATING!
Wiring (see fig.2)
1. Connect the electrical wires as follows. Connect the
black wire from the fixture to the black house (hot)
Wire. Connect the white wire from the fixture to the
white (neutral) house wire. Make sure all wire nuts are
secured. You may wrap the connections with electrical
tape.If your outlet box has a ground wire (green or bare
copper) connect fixture’s ground wire to it. Otherwise
attach the bare copper fixture wire to the green ground
screw on the single bar.
2.Tuck the wire connections neatly into the wall junction
box.
DOC20141201071
Fig.1
%R[
)L[WXUH
)L[WXUH
6XSSO\
*URXQG:LUH
VFUHZ
ZLUH
*URXQG:LUH
6LQJOH
+H[
3LSH6FUHZ
EDU
QXW
Fig.2
:KLWHRU
+286(
%ODFN
:,5(6
+RW
6PRRWK
),;785(
:,5(6
%ODFNRU
5LEEHG
:,5(6
),;785(
%DUH&RSSHU*URXQG
),;785(
:,5(6
&RSSHU
*URXQG
+286(
1HXWUDO
:,5(6
:KLWH
%DUH
*UHHQRU
:,5(6
+286(
(Not included)