Manual

The standard setting is for a seven minute count-down to be

started when the cat leaves the Globe. At the end of the count-

down the Litter-Robot will start its cleaning cycle. Any

subsequent tripping of the Cat Sensor starts a new seven minute

count-down, preventing the Globe from rotating with your cat

inside. You can adjust this time setting by pressing and holding

the Empty button for 5 seconds and then pressing the Reset

button to toggle through the settings.

(Blue: 3 minutes, Yellow: 7 Minutes, Red: 15 Minutes)

Caution:

Please make sure that your smallest cat weighs at least

5 lbs before operating the Litter-Robot in the unattended

automatic mode. Your cat must weigh at least 5 lbs to

trip the Cat Sensor.

Drawer Full Indicator (DFI)

Your Litter-Robot is equipped with

infrared emitters and sensors

located above the waste drawer that

detect when the drawer is full. The

Control Panel displays a blue

flashing LED when the DFI is

activated. The Waste Drawer is

checked every time the Globe

returns to home position. Upon the

first activation of the DFI, the blue LED flashes, and the Cat

Sensor remains active. Upon the 3rd activation of the DFI (after

2 more clean cycles), the Cat Sensor becomes inactive and the

unit will no longer cycle automatically. Check or empty Waste

Drawer and push the Reset button to cancel mode.

Automatic Night Light

Although cats in general have excellent vision in low light

conditions, as they get older their vision can diminish and the

Automatic Night Light (located in the upper Bonnet) is there to

assist elderly cats find the litter box in extreme low light

Toll Free: 877-250-7729 www.Litter-Robot.com