Manual

20
Toll Free: 877-250-7729 www.Litter-Robot.com
will affect the weight of the unit, including emptying the
Waste Drawer, adding or removing litter from the Globe, or
cleaning or moving the unit. When you are done, turn the
unit back on. The Litter-Robot will perform an initial Clean
cycle and the Cat Sensor will take a new measurement of the
unit’s weight.
The Reset button is another way to reset the Cat
Sensor after doing anything that affects the unit’s weight.
Press Reset firmly and quickly, then watch for the blue light
to flash to confirm you have reset the Cat Sensor. Be careful
not to rest on the unit as you press the button or your weight
will influence the reading.
Drawer Full Indicator (DFI)
The Litter-Robot is equipped with
infrared emitters and sensors
located above the Waste Drawer
that check if the drawer is full each
time the Globe returns to the Home
position. The Control Panel displays
a flashing blue light when the DFI is
activated. Upon the first activation
of the DFI, the blue light flashes,
and the Cat Sensor remains active. Upon the third activation
of the DFI (after 2 more Clean cycles), the Cat Sensor
deactivates and the unit will no longer cycle automatically.
Check or empty the Waste Drawer, then press Reset to
cancel the indicator and reset the Cat Sensor.
Automatic Night Light
Although cats generally have excellent vision, aging and
illness can diminish their ability to see in low light conditions.
The Automatic Night Light, located in the upper Bonnet, is
there to help guide your cat to the litter box. A light sensor
located above the Cycle button turns the Night Light on and
off automatically. Turn the Night Light function on and off by
pressing and holding the Power button (see
Control Panel -
Buttons section  Power Button
, page 13).