A×1 B×1 C×1 D×1 E×1 F×1 G×1 H×1 I×1 J×1 K×1 L×2 M×1 N×1 O×1 P×1 Q×1 R×2 S×2 T×2 U×2 V×2 W×2 X×4 Y×4 Z×4 AA×61 AB×8 AC×4 AD×8 AE×2 AF×2 AG×4 Standby Application
P I C E L F D A O K T B T S Q R S R N G H L M J U ×2 U
1 C D Z Y C D Y×4 Z×4 2 AA A AA×4
3 AA B AA×4 4 M 2 1 AA AA×4
5 2 1 O Take care to distinguish the top and bottom when installing Part O. N Take care to distinguish the top and bottom when installing Part N. 2 1 6 2 1 These Buckles must be inserted into the panel at the same time, and then push Part N and O down.
AA AA AA×8 8 2 1 AA P AA×4
9 AA I AA×7 10 J AA AA×4
11 U U X AA X×4 AA×14 12 If the cabinet is uneven, it can be adjusted by rotating the accessory X.
13 Install screws from inside the cabinet. AA Q AA×4 14 For smoothly assemble, please first distinguish the left and right slide rails. Part V is the left slide rail, and part W is the right slide rail.
15 AA K AA×4 16 Bent the drawer to 90° R S AA Bend the buckle, Install the screws.
17 T 18 Pull out the two Guide Rails completely at the arrow position. Using the Guide Rails on the left and right sides, snap the assembled drawers together as shown in the illustration, and then press thedrawer to stuck it completely.
19 Using the Guide Rails on the left and right sides, snap the assembled drawers together as shown in the illustration, and then press thedrawer to stuck it completely. Pull out the two Guide Rails completely at the arrow position.
21 AB AB AB×8 22 L L
23 If the spring shaft is lost,spare parts AF can be used. 2 3 AD G AC 1 AC×1 AD×2 24 If the spring shaft is lost,spare parts AF can be used.
25 If the spring shaft is lost,spare parts AF can be used. 2 E 3 AD 1 AC AC×1 AD×2 26 If the spring shaft is lost,spare parts AF can be used.