User's Manual

Answering System does not work, check the following:

1. BASE UNIT is plugged into the power source.

2. Reset the system by pressing the RESET button at the top side of the BASE UNIT.

Answering System does not answer calls, check the following:

1. ANSWER ON/OFF LED indicator is lit.

Answers calls only after 10 rings, check the following:

1. ANSWER ON/OFF LED indicator is lit.

2. Message Memory is not full.

Does not respond to remote commands, ensure the following:

1. Correct Remote Access Code is entered.

2. A TONE telephone is being used.

Messages are incomplete, ensure the following:

1. Message Memory is not full.

2. Caller may be hesitating and pausing for more than 7 seconds.

Answers calls but does not record messages, check the following:

1. ANNC/ICM switch is set to ICM.

2. Memory is not full.

3. Extension telephone was not picked up.

NOTE:

If none of the telephones in the house are working, disconnect one set at a time to verify

that none of the telephones are causing the problem. If you still have a problem after

doing this, and your telephone still does not work, please contact your local phone

company.

Problem Solving