User's Manual

86
Section 3: Configuring the Access Point
Linksys
Write Views Select the write access to management objects (MIBs) for
the group:
• write-all — The group can create, alter, and delete
MIBs.
• write-none — The group is not allowed to create, alter,
or delete MIBS.
Read Views Select the read access to management objects (MIBs) for
the group:
• view-all — The group is allowed to view and read all
MIBs.
• view-none — The group cannot view or read MIBs.
SNMP Groups This field shows the default groups and the groups that
have been defined on the AP.
Use the buttons on the page to perform the following tasks:
• Add: Add the new group to the SNMP Groups table.
• Remove: Remove the selected group from the SNMP Group table.
• Save: Apply and save the changed SNMP group settings.
•
Targets
An SNMP target receives trap messages and forwards them to the SNMP
manager. Inform messages are not supported. Each target is associated with
target IP address, UDP port, and SNMP user name.
NOTE:
Required SNMP user configuration ”Users” on page 125 should be
completed before configuring SNMP targets.
NOTE:
The access point supports a maximum of eight targets.
To display the SNMP Targets Configuration page, click the Configuration >
SNMP > Targets tab.
Figure 43: SNMP Targets