Owner's Manual

Setup Details

1•4

Tap Tempo Light

• TpLite - AlwaysOn: The TAP light on the device will ﬂash constantly, showing the

current tempo setting.

• TpLite - Flash 8: The TAP light will ash only 8 times, immediately after a new

Tempo value is set, and then remain unlit.

Firmware Version

Your device’s current ﬁrmware-ﬂash memory version is displayed here. This is an

informational screen only.

Pedal Calibration

Note: If you’ve just performed a Factory Restore on your device (see below), that process

included Pedal Calibration and it is not necessary to perform the following steps again.

However, you can use these instructions to perform just the Pedal Calibration process at any

time.

Before you put the POD HD pedal to use, it is recommended that you calibrate it to

optimize its functionality. Begin with POD HD powered off. Hold down the D footswitch

while powering the unit on, until you see the LCD display the following:

Please skip ahead to step 5 of the Factory Restore section on page 1•5 and follow the

remaining steps to complete the Pedal Calibration.