User's Manual
Table Of Contents
- Copyright
- Notice
- Trademarks
- LigoPTP 24 Full Outdoor Units
- LigoPTP 24 Feature Summary
- Radio Parameters
- Application Examples
- Technical LigoPTP 24 Specification
- Cable Requirements
- Labeling
- Resetting the LigoPTP 24 FODU
- Web Interface
- Command Prompt Interface
- Radial MSE
- LDPC
- Main Configuration
- System Configuration
- IP Configuration Window
- Ethernet Configuration
- VLAN Configuration
- QoS
- SNMP Configuration
- Alarm Management
- Performance Management
- Ethernet Statistics
- Configuration File
- License Management
- Command Line
- File System
- Security Commands
- Other Available Accessories
- List of Abbreviations
Technical Description & Configuration Guide RSSI Port
LigoWave Page 86
RSSI (Received Signal Strength Indicator) port is used to adjust the alignment of antenna for best
performance (for both rough and fine adjustment); this can be done using digital multimeter which is
connected to the RSSI port. The output of the RSSI port is DC voltage and varies depending on
received signal level.
The following chart and table shows typical relationship of the received signal level (Rx level) displayed
by LigoPTP 24 vs. RSSI port output voltage (RSSI Received Signal Strength Indicator). The RSSI
port is located on FODU. The evaluated Rx level has the error +/-2 dBm.
RSSI Port