Installation Guide

FAN

UNIVERSAL

WHEEL

KIT

ASSEMBLY

INSTRUCTIONS

CONTENTS:

ea.

Wheel

and

hub

assembly.

ea.

Axle

assembly

ea.

Axle

straps

(offset

u-shaped

straps)

ea.

Cotter

ea.

Handle

and

Support

Bar

ea.

U-clamp

ea.

U-clamp

flat

strap

ea.

nut

and

bolt

combination

PAGE 1
LI FAN UNIVERSAL WHEEL KIT ASSEMBLY INSTRUCTIONS CONTENTS: 2 ea. Wheel and hub assembly. 1 ea. Axle assembly 2 ea. Axle straps (offset u-shaped straps) 2 ea. Cotter pin 2 ea. Handle and Support Bar 4 ea. U-clamp 4 ea. U-clamp flat strap 10 ea.
PAGE 2
t LI Assembly Steps
PAGE 3
1. Properly support complete unit before attaching wheel kit. 2. Loosely attach axle straps to the cross brace located under the alternator end of the generator. 3. Slide the axle assembly through the u-shaped axle straps. 4. Slide one wheel assembly over each end of the axle shaft. 5. Insert one cotter pin through the keeper hole on each end of the axle shaft, twist each leg of the cotter pin 180 degrees towards the eye of the cotter pin. 6.