Owners manual
Installation
17 Emerson
®
MPH2
™
2.5 Installing Optional Items
The following items may be added to an MPH2 rack PDU system but are not required.
• RPC Basic Display Module
•Liebert
®
SN temperature/humidity sensors
2.5.1 RPC Basic Display Module
The RPC Basic Display Module (BDM) provides local display of parametric data, including electrical
status, temperature and humidity for all connected MPH2 rack PDU’s. Display information is
accessed via a navigation switch on the BDM. The RPC BDM is connected by cable to the MPH2 rack
PDU, allowing the user to install the display to suit the local reading requirements. A 6.5ft. (2m)
cable and general mounting provisions are provided. A single display can be used for up to four rack
PDU’s connected in a Rack PDU Array
™
.
The RPC BDM can be mounted in the rack with either the included hardware or with a cable tie
through the slot on the back of the module. Either method permits moving the BDM to a different
place in the same rack or to another rack.
Included Hardware
•RPC BDM, 1
• Spring Nut M5, 1
• Spacer Sleeve, 1
• Mounting Button, 1
• M5 Screw, 1
• Cable Clip, 1
Figure 13 RPC BDM
Scan-Switch
RJ-45 Input