User guide

54 Operation
Operation
4
Radio Operations
Be sure that both antennas are connected.
(Refer to the page 21)
Listening to the radio
1. Press RADIO&INPUT until TUNER (FM/AM)
appears in the display window. The last
received station is tuned in.
2. Press and hold TUNING (-/+) for about two
seconds until the frequency indication
starts to change. Scanning stops when the
unit tunes in a station. Or Press TUNING (-/+)
repeatedly.
3. Adjust the volume by rotating VOLUME on
the front panel or by pressing VOL (+/- ) on
the remote control
Presetting the Radio Stations
You can preset 50 stations for FM and AM (MW).
Before tuning, make sure that you have turned
down the volume.
1. Press RADIO&INPUT until the TUNER (FM/
AM) appears in the display window.
2. Select the desired frequency by using
TUNING (-/+).
3. Press ENTER (
) a preset number will  ash
in the display window.
4. Press PRESET (-/+) to select the preset
number you want.
5. Press ENTER (
). The station is stored.
6. Repeat the steps 2 to 5 to store other
stations.
Deleting all the saved stations
Press and hold CLEAR for two seconds.
“ERASE ALL” will  ash up. Press CLEAR again.
Then all the saved stations are deleted.
Improving poor FM reception
Press B (blue) (MONO/STEREO) colored button
on the remote control. This will change
the tuner from stereo to mono and usually
improve the reception.
HB905SA-AH.BUSALL_ENG_6865.indd 54HB905SA-AH.BUSALL_ENG_6865.indd 54 10. 10. 20  9:2310. 10. 20  9:23