Owner's Manual

7
Installation and Setup
Make one of the following connections, depending on
the capabilities of your existing equipment.
Tips:

Depending on your TV and other equipment you
wish to connect, there are various ways you could
connect the DVD/CD Receiver . Use one of the
connections described below.

Please refer to the manuals of your TV, VCR,
Stereo System or other devices as necessary to
make the best connections.
Caution:

Make sure the DVD/CD Receiver is connected
directly to the TV. Select the correct AV input on
your TV.

Do not connect your DVD/CD Receiver to TV via
your VCR. The DVD image could be distorted by
the copy protection system.
Video connection
Connect the MONITOR OUT jack from the DVD/CD
Receiver to the VIDEO IN jack on the TV using the
video cable (V).
Component Video connection
Connect the COMPONENT VIDEO OUT jacks from
the DVD/CD Receiver to the corresponding jacks on
the TV using an Y P
B PR cable (C).

If your television is a high-definition or “digital
ready” television, you may take advantage of the
DVD/CD Receiver ’s progressive scan output for the
highest video resolution.

If your TV does not accept your resolution setting,
abnormal picture appears on the screen. Please
read owner’s manual for TV then set the resolution
that your TV can accept.
Note:
The HDMI mode must be set to OFF for VIDEO OUT
and Component video connections.
TV Connection
HDMI OUT
HDMI OUT
OUT PUT
INPUT
L - AUX - R
MONITOR
Y
COMPONENT VIDEO (PROGRESSIVE SCAN)
Y
COMPONENT VIDEO /
PROGRESSIVE SCAN INPUT
L
VIDEO
INPUT
Installation and Setup
Rear of DVD/CD Receiver
Rear of TV
VC