Owner's Manual

3 System Setting
System Setting28
System Setting
3
Settings
Initial Setup
When you turn on the unit for the rst time, the
initial setup wizard appears on the screen. Set the
display language, network settings and speaker
setup on the initial setup wizard.
1. Press
1
(POWER).
The initial setup wizard appears on the screen.
2. Use
W/S/A/D
to select a display language
and press ENTER (
b
).
3. Read and prepare the preparations for the
network settings and then press ENTER (
b
)
while [Start] is highlighted.
If wired network is connected , the network
connection setting will automatically be
finished.
4. Select [Next] and press ENTER (
b
).
5. Press ENTER (
b
) to verify the test tone signals of
the speakers.
After verifying the test tone signals, press ENTER
(
b
) while [Stop] is highlighted. Select [Next]
and press ENTER (
b
).
6. Check all the settings that you have set in the
previous steps.
Press ENTER (
b
) while [Finish] is highlighted
to finish the initial setup settings. If there is any
settings to be changed, use
A/D
to select
[Previous] and press ENTER (
b
).