0 INSTALLATION INSTALLATION Before Installing Installation Overview Please read the following installation instructions first after purchasing this appliance or transporting it to another location. a Unpack and remove shipping material b Check and choose the proper location c Level the appliance d Install carpet spikes† e Reverse the door swing† f Connect to grounded outlet † If needed.
INSTALLATION 11 Installation Location Requirements sides and rear, recommended clearances should be considered for the following reasons: ENGLISH Before installing the appliance, check the following requirements for the installation location. Installation Location • A grounded electrical outlet should be located within 2 ft. (61 cm) of either side of the appliance. • Install the appliance on a level floor.
12 INSTALLATION One example shown uses vent grilles in the door. F J G 7.6 cm K E D L B 7.6 cm L I H a Upper vent opening with a minimum opening of 48 sq. in. (310 cm2) must be installed no lower than 6 ft. (185 cm) above the floor. Dimensions inch mm A 2 25 1/2 2 650 B 2 18 2 455 C 2 10 2 250 Ambient Temperature D 2 74 3/8 2 1889 E 2 74 1/8 2 1875 • Temperature must be between 50 ℉ (10 °C) and 95 ℉ (35 °C).
INSTALLATION 13 Unpacking the Appliance WARNING Removing Carton and Shipping Materials Unpack the appliance from carton and remove any tape and temporary labels from the appliance. • Do not remove any warning labels, the model and serial number label, or the technical sheet label that is located under the front of the appliance. Checking the Level Leveling the appliance prevents unnecessary noise, vibration and movement. Check whether the appliance is perfectly level after installation.
14 INSTALLATION 3 When the appliance is completely stable and all leveling feet are resting solidly on the floor, tighten the locking nuts a. WARNING • Take care when handling the carpet spikes. They are designed to pierce through the carpet backing and pad and are very sharp. Installing on Carpeting Follow these instructions when installing the appliance on carpeting. WARNING • The appliance is heavy. Two or more people are necessary to install the rear leveling feet and carpet spikes.
INSTALLATION 15 Using Non-skid Pads Non-skid pads prevent the appliance from shaking or shifting when opening or closing the door. Clean the floor to attach the non-skid pads. • Use a dry rag to remove foreign objects or moisture. If moisture remains, the non-skid pads may slip. 2 3 4 Adjust the level after placing the appliance in the installation area. Place the adhesive side a of the non-skid pads on the floor.
16 INSTALLATION 3 Repeat with the remaining hinge cover on the lower hinge assembly.
