Install Manual Wall Mounting Bracket Please read this manual carefully before operating your set and retain it for future reference. OSW100 P/NO : MFL63640561 (1407-REV00) www.lg.com (Brazil: www.lge.
COMPONENT Install manual Wall mount anchor 4 units Wall mount screw 4 units * Component of top wall mount Top wall mount Hanger 2 spacers (front) 2 spacers (back) 1 pin for fixing top wall mount 2 screws for attaching the hanger (M6 x L33 mm) * Component of bottom wall mount 1 bottom-right wall mount 2 1 bottom-left wall mount 2 bottom wall attaching brackets 8 washers
ENGLISH IMPORTANT SAFETY INSTRUCTIONS Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions. Warning This wall mount should be installed by a trained and experienced installer designated by the retailer. Having the product installed by a non-specialized installer is very dangerous and can cause damage or injury. Do not install the product where the weight cannot be supported.
BEFORE INSTALLATION * Do not use the product for purposes other than mounting a display on the wall. * When installing/using the wall mount, be cautious of product damage and avoid accidents. * If you have not fully read and understood the installation manual, do not install the product and contact the dealer to have a specialized installer install the product for you. * Install the product only on a vertical wall.
-- If the screws are not fully tightened when you fix the top and the bottom wall mount, check the length of the screws and tighten them again. -- Always install the display with 2 or more people. -- Work procedure VESA Screw 1. Remove the two VESA screws from upper back of TV when in an upright position. Hanger Screw for attaching the hanger Stand Stand attaching screws Bottom wall mount Stand attaching screws 2. Use the screws for attaching the hanger to tighten the hanger as shown.
3 How to attach to masonry walls Please follow the below direction. -- Check the material of the wall and the thickness of the finishing. -- Use the anchors for wall material of concrete, light concrete, strong natural stone, soft natural stone masonry brick and hallow block that do not crack. -- Do not mount the device on the walls made from plasterboard or medium density fiberboard (MDF). In this case, the anchor and screws must be inserted into the concrete behind the finish surface.
ENGLISH 4 How to Install the Top Wall Mount Top wall mount cover →→ Open the top wall mount cover completely. →→ Place the top wall mount onto the area of the wall where you want to install it, and then check if the wall mount is level using a leveler. Top wall mount cover Wall mount screw →→ Attach wall mount screws as shown in the illustration.
5 How to Install the Bottom Wall Mount How to Select the Installation Location of the Bottom Wall Mount Product packaging box [unit : mm] ➊ 541 ➌ ➋ 350 90˚ 350 Product packaging box ➍ ➊ Place the box on the bottom center of the attached top wall mount and place the box at a right angle (90 degrees) to the top wall mount as shown in the figure. ➋ Find the V on the bottom of your box, and mark the point facing it on the wall [(a) in the figure].
ENGLISH 6 How to Attach the Top Wall Mount to the Product - Two or more people are needed to lift and install the product. ➊ ➋ Hang the hanger on the top wall mount as shown in the figure. →→ Two people must lift the TV set attached to the hanger and carefully check from both sides whether it is properly installed. →→ Make sure that the product is fixed securely by lightly pulling on the bottom of the TV. →→ The product should be about 10 mm apart from the wall.
8 How to Adjust the Level of the Product If the product is not level after installation, lift the product slightly so that it moves to a position where it is level. Adjust the horizontal levels of the TV set by rotating it centered in the top wall mount. Lifting Point Lifting Point 9 How to Tidy Up Cables -- Tidy up cables as shown in the illustration. Purchase a band for tidying up cables or use the band that comes with the TV.
[ unit : mm ] Hanger 238 99 3 7 8.5 210 18.5 Top wall mount 40 18.5 160 Bottom wall mount Width (mm) Height (mm) Depth (mm) Weight (kg) Max.UL Load Capacity (kg) Top Assembly 160 40 18.5 Hanger Assembly 238 99 18.5 1.1 30 Lower Assembly 169.9 34.9 49.
The model and serial number of the product is located on the back or one side of the product. Record it below should you ever need service.
