- LG Stereo System User's Manual

MINI Hi-Fi SYSTEM ] USER GUIDE
11
Troubleshooting
Symptom Cause Correction
Specifications
General
Net Weight 5.57 kg (MCD212)
5.36 kg (MCD112/MCD112B)
External dimensions (WxHxD) 270 x 310 x 390 mm
Tuner
FM Tuning Range 87.5 - 108.0 MHz or 65 - 74 MHz,
87.5 - 108.0 MHz
AM Tuning Range 522 - 1620 kHz or 520 - 1720 kHz
Amplifier
Output Power 100W + 100 W (MCD212)
50W + 50 W (MCD112/MCD112B)
T.H.D 0.5 %
Frequency Response 40 - 20000 Hz
Signal-to-noise ratio 75 dB
CD
Frequency response 40 - 20000 Hz
Signal-to-noise ratio 75 dB
Dynamic range 75 dB
Speakers
MCS212F Type Bass Reflex 2 Way 2 Speaker
Impedance 4
Rated Input Power 100 W
Max. Input Power 200 W
Net Dimensions (WxHxD) 220 x 326 x 272 mm
Net Weight (1EA) 3.25kg
MCS112F Type Bass Reflex 2 Way 2 Speaker
Impedance 4
Rated Input Power 50 W
Max. Input Power 100 W
Net Dimensions (WxHxD) 200 x 326 x 228 mm
Net Weight (1EA) 2.92 kg
No power.
No sound.
The unit does not
start playback.
The remote
control does not
work properly.
Unable to record.
The power cord is disconnected.
The power of the external source
equipment is turned off.
The speaker cable is connected
to a wrong position.
• An unplayable disc is inserted.
The disc is placed upside down.
The disc is not placed within the
guide.
The disc is dirty.
The remote control is not pointed
at the remote sensor of the unit.
The remote control is too far from
the unit.
There is an obstacle in the path
of the remote control and the unit.
The batteries in the remote con-
trol are exhausted.
• Record protect tabs are removed.
• Plug the power cord into the wall
outlet securely.
• Switch on the external source
equipment.
• Set the speaker cable to the
correct position, then turn on the
unit again by pressing POWER.
• Insert a playable disc.
• Place the disc with the playback
side down.
• Place the disc on the disc tray
correctly inside the guide.
• Clean the disc.
• Point the remote control at the
remote sensor of the unit.
• Operate the remote control within
about 23 ft (7 m).
• Remove the obstacle.
• Replace the batteries with new
ones.
• Cover holes on back edge of tape
with tap.
Designs and specifications are subject to change without notice.