Owners manual

Saving a Direct Connect Number
1. Use yourkeypad to entera Direct Connect number.

The Direct Connect number may be the 10-digit
wireless phone number of the contact.
– or–

The Direct Connect number may be a unique
numbermade up of three sets of digits separated
by asterisks (forexample, 444*5555*111). When
saving this type of number, always include the
asterisks ( ).
2. Press Options (right softkey) > Save .
3. Select New Entry or Existing Entry and press .
4. Select a phone type for the entry and press .

Select Mobile + DC if the wireless phone number
and the Direct Connect number are the same.

Select DC Only if the Direct Connect number is
different from the wireless phone number. Make
sure to include the “*”( ) between the sections
of a DC Only number.
5. Press Done (left softkey)to save the entry.
Blocking a Direct Connect Number
1. Press > Contacts .
2. Highlight an entry and press .
3. Select the DC-capable phone number. (See “To tell
if a numberis a valid Direct Connect number:”on
page 34.)
4. Press Options (right softkey) > Block DC .
5. Press Block (left softkey)to block the number.
Tip
You can also save a Direct Connect numberfrom
History. From a History listing, press
Options > Save
Contact
, and then complete steps 3–5 above.
Note
All Direct Connect users with Nextel or
PowerSource phones must ALWAYS use an “*”
between sets of digits, even if they are calling
anotheruser whose DC numberis the same as their
wireless phone number. Make sure to include the
asterisks when giving yournumberto a Nextel or
PowerSource user(forexample, if yournumberis
555-555-1234, when giving it to a Nextel or
PowerSource user, it should be 555*555*1234).
48 Section 2B. Nextel Direct Connect
LX400_Eng_0603.qxp 6/3/09 10:51 AM Page 48