Full Product Manual

22 INSTALLATION
Use the wrench (included with the owner's
manual) to turn the nut in the door hinge to adjust
the height. Turn the nut to the right to raise the
door or to the left to lower it.
Right Refrigerator Door
The right refrigerator door does not have an
adjustable nut.
If the space between the doors is uneven, follow
the instructions below to align the right door:
1 Lift up both the inner and outer door sections
of the right door to raise them at the middle
hinge. (It may be easier to lift them with the
doors open.)
2 While the door is lifted, have an assistant
insert the snap ring on the middle hinge. The
snap ring may differ depending on the model.
• Snap ring type A
Use pliers to insert the snap ring on the
middle hinge of the inner door section as
shown. Insert additional snap rings until the
right door is aligned.
• Snap ring type B
Insert only one snap ring on the middle
hinge of the inner door section as shown.
Three snap rings of different thicknesses
are provided.
- If a snap ring is already inserted on the
middle hinge, remove the snap ring
before inserting a new snap ring.
CAUTION
• The door is heavy. To avoid injury, use two or
more people to lift and align the refrigerator
door.
• Small parts are a swallowing hazard for small
children. Keep snap rings out of the reach of
children.
• Do not insert the snap ring on the hinge of the
outer door section.
NOTE
• The number of freezer drawers may vary
depending on the model.
Turning on the Power
• After installing, plug the refrigerator’s power
cord into a 3-prong grounded outlet and push
the refrigerator into the final position.
CAUTION
• Connect to a rated power outlet.
• Have a certified electrician check the wall outlet
and wiring for proper grounding.
• Do not damage or cut off the ground terminal of
the power plug.
Position the Refrigerator
• Arrange the coil of tubing so that it does not
vibrate against the back of the refrigerator or
against the wall. Push the refrigerator back to
the wall.
Start the Icemaker
• If the water line is connected, turn the icemakers
on.
- To turn the icemakers on, refer to Control
Panel in the Operation section.
• The icemaker will not begin to operate until it
reaches its operating temperature of 15 °F (–9
°C) or below. It will then begin operation