Full Product Manual

55TROUBLESHOOTING
ENGLISH
Steam Functions (Steam Models)
Problem Possible Cause Solutions
Water drips from nozzle when
STEAM CYCLE starts
This is normal.
• This is steam condensation. The
dripping water will stop after a short
time.
Garments still wrinkled after Steam
Fresh™
Too many or overly different
types of garments in dryer.
• Small loads of 1 to 5 items work best.
Load fewer garments. Load similar
types of garments.
Creases or pleats are gone from
garments after Steam Fresh™
The function of this cycle is to
remove wrinkles from fabric.
• Use an iron to replace creases and
pleats in garments.
Garments have static after using the
Reduce Static option
This is normal.
• The amount of static experienced will
depend on the individual moisture
level in the skin.
Garments are too damp or too dry
after using the Reduce Static option
Correct drying options not
selected.
• Select the load weight manually
before starting the Reduce Static
option.
Steam does not generate, but no
error code is shown
Water level error. • Unplug dryer and call for service.
Water drips from door during
STEAM CYCLE
This is normal.
• Condensation will normally form on
the inside of the dryer door during
steam operation. Some condensation
may drip out the bottom of the door.
Steam is not visible during STEAM
CYCLE
This is normal.
• Steam vapor is difficult to see
when the door is closed. However,
condensation will normally form on
the inside of the dryer door if the
steam system is operating normally.
Drum does not turn during STEAM
CYCLE
This is normal.
• The drum is turned off so that the
steam vapor remains in the drum.
The drum will normally turn for about
2 seconds once a minute.
Cannot see steam vapor at the
beginning of cycle
This is normal.
• Steam is released at different stages
of the cycle for each option.
Odors remain in clothing after
Steam Fresh™
Steam Fresh™ did not remove
odor completely.
• Fabrics containing strong odors
should be washed in a normal cycle.