Use and Care Manual

ManualsBrandsLG Electronics ManualsAppliancesCordZero Cordless Stick Vacuum Cleaner

Before Using

•

The dust bin lid must be in place before using

the product. Otherwise, the suction strength will

deteriorate and cleaning will not be satisfactory.

•

Support the bottom of the product when cleaning

an elevated surface.

•

Store the vacuum in the charging station or at

on the oor when not in use. Leaning the vacuum

against a wall or chair can result in product

damage or personal injury if the vacuum falls.

•

Make sure that the exhaust lter is properly

assembled before using the product.

•

Environmental conditions such as temperature and

humidity may cause occasional static buildup to

accumulate on the product. If this is a persistent

issue, contact an LG Electronics customer

information center.

•

Any foreign object on the inlet port or extension

pipe will prevent the product from functioning

properly. Make sure to remove any foreign object

such as a sock or stocking before using the

product.

•

The battery runtime will be shortened after using

the product repeatedly for an extended period due

to its characteristics.

•

After extended use, all batteries experience

reduced battery life.

•

The last bar on the battery indicator begins to ash

when the battery needs to be recharged.

•

Please use the product at normal room

temperatures as the battery runtime will deteriorate

severely if used at temperatures lower than 41°F

(5°C) or higher than 100°F (38°C) for an extended

period of time.

•

Refer to product specications for battery run time

details.

•

These times are a guide only and may be shorter

for some surfaces.

•

Follow manufacturer's recommendations when

cleaning ooring, carpets, and rugs.

•

To avoid marking polished ooring, keep the nozzle

and brushes free from grit, sand, or abrasive

objects.

•

To maintain battery life on dual-battery models,

swap the positions of the two batteries periodically,

between the main body and the auxiliary charging

station.

Operation

Attaching the Wand and

Accessories

Attach the wand by sliding it onto the inlet on the

product body until it clicks into place. To detach

the wand, press the release button. Attach or

detach the accessories to the end of the wand in

the same way. Insert the battery into the cavity

at the back of the vacuum.

Inlet port

Extending

wand

Battery

Product

body

To extend the wand, press the button on the

back of the wand and slide the outer pipe until it

clicks into place at the desired length. The wand

extends in four steps.

Wand length

extension button

Accessories can be attached to either the

extending wand or the product body.

Extending wand

CAUTION

•

Do not use attachments to clean TVs, LCDs, or

monitors as they may scratch these surfaces.

•

Keep ngers away from pinch points when

assembling the wand or attachments.

•

If any foreign object is sucked into the inlet during

cleaning, operation of the vacuum cleaner might

stop in order to prevent damage to the body or

motor. Immediately stop using the vacuum cleaner

and remove the object before resuming cleaning.

Summary of content (7 pages)

PAGE 1
Operation Before Using • • • • • • • • • • • • • • • The dust bin lid must be in place before using the product. Otherwise, the suction strength will deteriorate and cleaning will not be satisfactory. Support the bottom of the product when cleaning an elevated surface. Store the vacuum in the charging station or flat on the floor when not in use. Leaning the vacuum against a wall or chair can result in product damage or personal injury if the vacuum falls.
PAGE 2
Charging the Battery 1 Put the product on the charging station. • The battery indicator has 3 bars to indicate the charge level. The bars will flash during charging. 2 Insert the battery into the auxiliary charging station. Auxiliary battery charge indicator 2 An auxiliary battery can be charged in the base of the charging station. • The auxiliary charge indicator will flash until the auxiliary battery is fully charged. CAUTION • Make sure to securely fit the unit on to the charging station.
PAGE 3
Using the Nozzles • The nozzles included may vary by product. • The nozzle can be attached to the product body or extension pipe. • Adjust the suction lower if the inlet gets stuck on the floor, carpet, or power punch or higher if you need more power. CAUTION • Do not use the product for anything other than domestic household purposes. Crevice Tool Use to remove dust from corners or narrow spaces. Combination Tool This accessory is helpful for cleaning corners or small gaps.
PAGE 4
Maintenance Emptying the Dust Bin 1 Remove the battery from the unit before cleaning the dustbin. 2 Hold the dust bin over a wastebasket or trash can. 3 Press the release button at the bottom front of the dust bin to open the bin and shake to empty it. • Be careful as dust/foreign matter may spill out when you open the dustbin. Release button 4 Insert the crevice tool into the large dust separator and turn it counterclockwise to remove it.
PAGE 5
3 Clean the exhaust filter with a brush or running water. • To maintain cleaning performance, remove the dust from the exhaust filter at least once a month. • Allow the exhaust filter to dry out of direct sunlight in a well-ventilated place. Reinstalling the filter before it is completely dry may result in mildew or odor. WARNING • Never wash the product body or separator with water. Water may reach the motor and cause electric shock or fire.
PAGE 6
Cleaning the Power Floor/Carpet Nozzle CAUTION • Keep fingers away from pinch points when removing and assembling the brush. Check the brush and roller heads before using and clean as needed. • Do not immerse the brush or head in water or rinse 1 Remove the nozzle from the product. Press the release button to remove the head from the wand or product body. • Do not pick up oils or liquids with the vacuum. Turn the head upside down and insert a flatblade screwdriver in the cover lock slot.
PAGE 7
Before Calling for Service Save time and money by checking the following before calling for service. Symptom The vacuum does not operate. Cause Battery is dead. Vacuum is powered off. Dust bin is full. Suction is weak. Vacuum won't charge. Filter is clogged. Power adapter is not connected to the charging station. • Plug the adapter firmly into the charging Power cord is unplugged. Motor is cooling. The dust bin is full. The filter is dirty. The pre-filter was installed while damp or wet.