Owners manual

GB-30

WATCHING TV / PROGRAMME CONTROL

TURNING ON THE TV

- When your TV is turned on, you will be able to use its features.

➊

Firstly, connect the power cord pushing it firmly home and check the main power on the TV.

At this stage, the TV switches to standby mode. (The power indicator on the TV illuminates red.)

➋

In standby mode to turn TV on, press the INPUT or P∧∨ (Programme Up/Down) button on the TV or press the

POWER, INPUT, P∧∨ or NUMBER button on the remote control and the TV will switch on.

Initial Setting

This function guides the user to easily set the optimal viewing mode and tune the available channels. When

you turn the TV on for the first time after purchase or performing the OPTION > Factory Reset, this

function will begin automatically.

Select the mode for your environment. Each mode provides the optimal picture settings for each

environment.

Select “Home Use” to use the TV in home.

Select “Store Demo” to use the TV in store. Even if the user changes the picture setting, the TV will

automatically reset to initial settings after a certain period of time.

The mode (Home Use, Store Demo) can be changed in the OPTION > Mode Setting menu.

Select one of the three tuning modes Freesat & Antenna, Freesat or Antenna.

After the Freesat signal is detected, enter your full postcode (including any spaces e.g. TW19 7RP).

The Freesat service uses Astra 2 at 28.2° East, and Eurobird 1 at 28.5° East satellites.

If new software is detected and installed, you can use the initial setting again.

First tunes the Freesat programmes, then Digital and analogue terrestrial programmes.

Note:

a. If you close without completing the initial setting, the Initial Setting menu can be displayed again.

b. Press the RETURN button to return to the previous screen.

c. For those countries without confirmed DTV broadcasting standards, some DTV features might not work,

depending on the DTV broadcasting environment.

■

PROGRAMME SELECTION

➊

Press the P∧∨ (Programme Up/Down) or NUMBER buttons to select a programme number.

VOLUME ADJUSTMENT

➋

Press the + or - button to adjust the volume.

If you wish to switch the sound off, press the MUTE button.

You can cancel this function by pressing the MUTE, + , - or AV MODE button.