Owners manual

27
206-4190
There are three options for cloning a Master TV Setup (including a TV that has been set up using the
Express Script Installer Menu Wizard):
• Using a USB memory device
• Using a TLL-1100A clone programmer
• Using a LT2002 clone programmer
Each option is described in further detail on the pages that follow. As you perform cloning procedures, be
sure to complete each task as indicated. If a procedure or step is omitted or not performed completely,
cloning may not work. At each step, pay attention to ensure the TV screen shows the proper message
when cloning. If the message indicated does not appear, there is a problem with that step, and cloning
may not be successful.
Caution: Copying a blank or incorrect memory into a TV from a clone programmer will
cause the TV to operate erratically or become inoperable.
Caution: Do not connect a clone programmer to a PPV card installed in the Master or
Target TVs, as this will damage the clone programmer and the PPV card.
Cloning Overview
IMPORTANT CLONING INFORMATION
Before you begin cloning:
• Complete the Custom Master TV Setup procedure or run the Express Script Installer Menu Wizard (see
pages 11 to 14 or pages 9 to 10, respectively).
• All equipment should be connected to power and turned ON.
• Learning and Teaching is only possible between identical model TVs.
• If using a USB memory device, ensure the USB device has been formatted with FAT format.
• For both Master and Target TVs—If using a clone programmer, ensure the TV is tuned to either an Aux
input or an analog (not a digital) channel.
• LT2002 only—Make sure the batteries in the clone programmer are fresh. If batteries are removed, the
clone programmer clock time (if set) will be lost (see page 33 for information on the clone programmer
clock).
Caution: Do not unplug the TV power cord or remove/disconnect the USB memory device/
clone programmer while Learning or Teaching, as doing so may cause the TV to malfunc-
tion or harm the USB device/clone programmer, respectively.