User manual

98
APPENDIX
The remote is a multi-brand or a universal remote. It can be
programmed to operate most remote-controllable devices of
other manufacturers.
Note that the remote may not control all models of other
brands.
PROGRAMMING THE REMOTE CONTROL
(Only 37/42/47/52LY9
*
, 50/60PF9
*
)
To find out whether your remote can operate the device
without programming, turn on the device such as a DVD
or VCR and press the corresponding mode button on
the remote.
After that, press the POWER button. If the device is
turned off then it responds properly and the remote
need not to be programmed.
If not, the remote should be programmed to operate
the device. The programming procedures are explained
below.
Press the MENU and MUTE button continuously at the
same time for 2 seconds, the current selected device
button will be illuminated.
If you don't press any button for 20 seconds, the light
on the mode button will be turned off. In that case, you
have to repeat from step 2.
Enter code numbers using the number button on the
remote by referring the code table on the following
pages. When pressing the button, the light blinks at a
time.
If the device turned off, the programming is successful.
Press the MENU button to store the code. After blinking
twice, this code is stored.
Test the remote functions to see if the device responds
properly. If not, repeat from step 2.
1
2
3
4
5
APPENDIX