User's Manual Part 1

ENGLISH
16
Handling
For safety reasons, be sure to turn off the power of each equipment when detector is not used.
Location of Cables
Make sure all cables are located so that they cannot be stepped on, tripped over,
or otherwise subjected to damage or stress.
Maintenance and Inspection
If the detector is defective, do not disassemble the detector randomly. Maintenance of the
detector should be done by an manufacturer.
Battery
This product includes a battery. Please charge the battery fully before using the newly purchased
detector for the first time.
• The battery is a consumable component. Its usable capacity reduces gradually over long-term
use.
• Contact the manufacturer if any issues arise while removing or replacing the battery.
• How to replace the batteries, please refer to the user manual.
• Always use batteries approved and certified by manufacturer.
- Failure to do so may cause a fire or explosion.
• Do not store the product in an enclosed space (bags, etc.) with the power on repeatedly or for
long periods.
- Overheated batteries may cause fire.
• Do not expose the product to flames.
- This may result in explosion or fire.
• Keep the product away from metallic objects, such as car keys and paper clips, when storing or
moving.
- Excess current may cause a rapid temperature increase, resulting in fire or burns.
• Contact the manufacturer if the battery leaks or emits an odor.
- Otherwise, it may cause explosion or fire.
• Do not recharge the product using a power supply or circuit other than the one supplied with
the product.
- This may damage the battery or cause a fire
Do not install the ME Equipment in a location without easy disconnect accessibility.
Changing the IT-Network at your own discretion may cause various problems. If you experience
issues with your IT-Network, please contact the manufacturer to take the appropriate measures.
MANUFACTURER will make available on request circuit diagrams, component part lists,
descriptions, calibration instructions, or other information that will assist SERVICE PERSONNEL
to repair those parts of ME EQUIPMENT
Indications
The device is intended to capture for display radiographic images of human anatomy including
both pediatric and adult patients. This device is used for generating diagnostic images by
converting x-rays into electronic signals. Excluded from the indications for use are mammography.