Installation Manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 1 of 2

EEI –2222/2223 CHAIR

Hardware:

Component:

Bolt M8x57mm x 8

Flat Washer M8 x 8

Chair Body x1

Back Leg x2

Thank you for purchasing the MODWAY CHAIR!

Before you start, here is some helpful advice:

1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step

instructions.

2.Owing to the size and weight of the dining chair, we recommend that it is assembled by two adults, on a

carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.

3.Please do not use any tools other than those provided or recommended in these instructions.

4.Please do not throw away any of the packaging or instructions until you have checked all the components and

hardware and the furniture is fully assembled.

5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the

components from time to time, so please save the tools that have been provided.

6.Please keep all pieces out of reach of small children.

Front Leg x2

Spring Washer M8 x 8

Allen Wrench x 1

PAGE 1
EEI –2222/2223 CHAIR Thank you for purchasing the MODWAY CHAIR! Before you start, here is some helpful advice: 1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step instructions. 2.Owing to the size and weight of the dining chair, we recommend that it is assembled by two adults, on a carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes. 3.
PAGE 2
EEI –2222/2223 CHAIR STEP 1: Please put the Chair Body (1) upside down on a carpeted or padded area. Then open the zipper on the bottom of Chair Body (1), to make the inside of the Chair Body(1) fully visible. Please find Legs (2&3) package and hardware package inside of the Seat Chair Body (1). Insert 1 piece of Front Leg (2) into the left upper hole on bottom of the Chair Body (1) as shown. Attach by using 2 pieces of Bolt (A), 2 pieces of Spring Washer (B) and 2 pieces of Flat Washer (C).