Instructions / Assembly

INSTALLATION
CAUTION: NOTE THAT THIS MANUAL IS WRITTEN WITH THE ASSUMPTION THAT THE
INSTALLER POSSESSES SKILL IN THE PROPER USE OF HAND AND POWER TOOLS, AND IS
FAMILIAR WITH THE ENVIRONMENT BEHIND THE SURFACE OF THE WALL OR CEILING
WHERE THE SPEAKERS WILL BE INSTALLED.
TO INSTALL:
1. Select speaker mounting location. Route speaker cable from source to this location.
Note: We recommend the use of 16/2 (minimum) class 3 speaker wires.
2. Attach wings to back plate of Pre-Construction Bracket (refer to Figures 1A and 1B). Only two
wings are required for each back plate. Select the mounting arrangement that best suites your
specific application.
Note: The wings are designed to be shortened as required.
3. Attach the Pre-Construction Bracket in the desired location to the underside of framing members
so that after drywall installation, the bracket and the wings are sandwiched between the drywall
and the framing member (ensure “FRONT” is facing into the room) (refer to Figures 1A and 1B).
If the mounting area is too congested to use both mounting wings you can drive screws through
the back plate directly into the framing member.
4. Loop the speaker wire and attach it to the wire management loops on the back of the bracket.
5. After drywall installation install speakers in holes provided by drywall installer. Follow instructions
included in speaker packaging.
Pre-Construction Bracket Kit
Cat. Nos.
AEPC8
AEPI6
AEPI8
PCC55
Installation Instructions
This package contains:
ABS Backplate (2)
14.5" Aluminum Wings (4)
PK-93361-10-00-2B