Operation Manual

Table Of Contents
Attention: Do not touch the contact edge of the memory module. Otherwise the memory module might get
damaged.
To replace a memory module, do the following:
1. Disable the built-in battery. See “Disabling the built-in battery” on page 90.
2. Ensure that the computer is turned off and disconnected from ac power and all cables.
3. Close the computer display and turn the computer over.
4. Remove the base cover assembly. See “Replacing the base cover assembly” on page 97.
5. Open the latches on both sides of the memory slot at the same time
1 , and then remove the memory
module
2 .
6. Insert the new memory module into the memory slot at an angle of about 20 degrees 1 . Pivot the
memory module downward until it snaps into place
2 . Ensure that the memory module is firmly installed
in the memory slot and cannot be moved easily.
7. Reinstall the base cover assembly.
Chapter 9. Replacing devices 99