Desktop Computer Hardware Installation and Replacement Guide

This section provides instructions on how to replace the diskette drive.
1. Remove the computer cover. See “Removing the cover” on page 12.
2. Remove the front bezel. See “Removing and replacing the front bezel” on page
14.
3. Disconnect the signal and power cables from the rear of the diskette drive.
4. Press the release button and slide the diskette drive out the front of the
computer.
5. Remove the retainer bracket from the failing diskette drive and install it on the
new diskette drive.
6. Slide the new diskette drive into the drive bay until it snaps into position.
7. Connect the flat cable to the new diskette drive.
8. Replace the front bezel.
9. Go to Chapter 4, “Completing the parts replacement,” on page 47.
Replacing a memory module
Attention
Do not open your computer or attempt any repair before reading the “Important safety
information” in the Safety and Warranty Guide that was included with your computer. To
obtain a copy of the Safety and Warranty Guide, go to the Support Web site at
http://www.lenovo.com/support.
Figure 30. Removing the diskette drive
Figure 31. Retainer bracket for diskette drive
36 Hardware Installation and Replacement Guide