User Guide Personal Computer 8129, 8132, 8133, 8134, 8135, 8136

Appendix C. Manual modem commands

The following section lists commands for manually programming your modem.

Commands are accepted by the modem while it is in Command Mode. Your

modem is automatically in Command Mode until you dial a number and establish

a connection. Commands can be sent to your modem from a PC running

communication software or any other terminal devices.

All commands sent to the modem must begin with AT and end with ENTER. All

commands can be typed in either upper or lower case, but not mixed. To make the

command line more readable, spaces can be inserted between commands. If you

omit a parameter from a command that requires one, it is just like specifying a

parameter of 0.

Example:

ATH [ENTER]

Basic AT commands

In the following listings, all default settings are printed in bold text.

Command Function

A Manually answer incoming call.

A/ Repeat last command executed. Do not

precede A/ with AT or follow with ENTER.

D_ 0 - 9, A-D, # and *

L last number redial

P pulse dialing

Note: Pulse dialing is not supported for

Australia, New Zealand, Norway, and South

Africa.

T touch-tone dialing

W wait for second dial tone

, pause

@ wait for five seconds of silence

! flash

; return to Command Mode after dialing

DS=n Dial one of the four telephone numbers

(n=0-3) stored in the modem non-volatile

memory.

E_ E0 Commands are not echoed

E1 Commands are echoed

+++ Escape Characters - Switch from Data Mode

to Command Mode (T.I.E.S. Command)

H_ H0 Force modem on-hook (hang up)