Owners Manual

Installation

In this chapter you’ll learn more about the connections,

controls and possible applications of your Lehmannaudio Linear

headphone amplifier.

1 | Unpacking

After unpacking the Linear check it for possible transport damages. If you notice

visible damages, you must by no means connect the device to mains. In this case

consult your dealer immediately.

The delivery comprises the following components:

≠

Linear unit

≠

Power cord

≠

User manual

≠

Guarantee voucher

Note

We recommend keeping the entire packaging for later shipment.

That way you will avoid transport damages. Use by no means

‘foam chips’ or similar packaging material. Otherwise the device

will jolt through to the bottom of the cardboard box during

transport and can be damaged! If the original packaging is no

longer available, it’s best to use bubble wrap in which to wrap up

the device in a generous manner. Finally the whole should be put

into a solid cardboard box.

2 | Placement

Always put the Linear on a solid base. Alternatively the device may also be

mounted under a table using the optional accessory kit. Due to its compact

dimensions and low weight you can take the Linear easily with you.

3 | Wiring

First check the present mains voltage since the Linear can only be operated on

the mains voltage which the unit has been designed for. This can be read on a

sticker on the bottom side of the device. Now connect the Linear to the mains

grid using the power cord and the mains inlet located on the rear side of the

unit.

Observe the safety notes from page 34!

Linear