User's Guide

Leedarson Lighting
a compatible wireless switch that uses the same wireless protocol as the bulb.
1.3 Leave your fixture on
If your switch or fixture is OFF,or is turned OFF, then control and communication from the App, or
wireless switch, to the LED Bulb is lost.
Inclusion Procedure
The following are the general procedures for the Zigbee bulb to be “included” into the network:
1. Screw the bulb into a standard socket.
2. Turn on the bulb with your wall switch to apply power to the bulb.
a) If you’re not using a wall switch, then use your alternate method to apply power to the bulb.
3. Activate the “inclusion” mode on your Zigbee controller or gateway.
a) This may also be done through your associated app, if your ecosystem has that capability.
4. Toggle the wall-switch, from OFF, then to ON.
a) Or use your alternate method to toggle power from OFF, then to ON.
5. The LED bulb will flash once if it has been successfully “included” into your Zigbee network.
Note: If you are using 3rdpartyZigbee Controller or Gateway, please refer to 3rdParty’s instruction on
how to add a new device to your network.
Note 2: If the bulb will not join the network after repeated attempts, please use the Factory Reset
procedures to clear the bulb’s settings.
1.4 Factory Reset Procedure
Physically switch the bulb on and off six (6) times for intervals of 0.5-2seconds. After the 6thtime, the
bulb will flash twice indicating that it’s successfully reset.