User's Manual

Venue 2 Wideband Receiver
LECTROSONICS, INC.
14
Talkback Setup
Talkback is a special function that re-directs the audio
output of the transmitter in use to a different receiver
module when a button is pressed on the transmitter.
The normal use is to provide a “com” channel so the
person using the transmitter can have a direct line to
the crew or production staff. The HH hand held trans-
mitter provides a programmable switch on the housing
that can be configured for this function. The switch
function is configured from the LCD menu on the
transmitter.
Button
(none)
Mute
Ta lkBk
Programmable button
As long as the button is held in, the audio will ap-
pear at the designated talkback channel rather than
the channel used for program audio. A simple setup
screen in the Venue 2 receiver makes it easy to des-
ignate channels with this function enabled and which
output will deliver the talkback audio.
Selected receiver
(channel)
Highlight to select
the receiver
Highlight to
change settings
If multiple channels have talkback enabled and share
the same talkback channel, the audio outputs from
all of them will appear simultaneously (mixed) at the
talkback output channel if multiple buttons are pressed
at the same time.
Group Tuning
Up to 32 frequencies can be stored in each of four
groups labeled U, V, W and X. The groups are com-
monly used to make setup easier for specific locations
and purposes.
A setup screen is provided to assign each receiver to a
particular group. The group frequencies can be edited
by selecting MODIFY GRP.
Select the
receiver
Assign the
receiver to
group
Change frequencies
within a group
About Active Alerts
When a system fault occurs, such as a short in an an-
tenna input when antenna power is turned on, the alert
LED on the front panel will start blinking.
Alert LED
NOTE: In the case of shorted antenna input, the
antenna power will also be turned off.
When the Alert LED is blinking, navigate to the SYS-
TEM INFO screen on the LCD to read and reset the
alert message.
A description of the fault will appear in the display. If
there is more than one fault, the highest priority ot
most recent will appear. When it is reset, the next one
in the list will appear.