Specification

Dalton Enterprises, Inc., 131 Willow Street, Cheshire, CT 06410
Phone [phone] • Fax [phone] • www.latexite.com
Revised 1/26/09
TECHNICAL DATA SHEET
Latex•ite
®
2X CRACK FILLER
Manufacturer Product#: 31263
UPC#: 090932312630
Appearance:
Brown Liquid, dries black.
Maximum VOC:
Less than 50 g/l
Application Temperature:
55º F and rising.
Specific Gravity:
.95-1.05
Viscosity:
4,000-7,000 cps
Weight Per Gallon:
7.8-8.6
Color:
Brown
Consistency:
Thick liquid
Boiling Point:
>212º F
Cure Time (50% relative humidity, 70º F):
24-48 hours.
Freeze ability:
Do not allow to freeze.
Container Size & Weight:
1 gallon, 8.2 lbs. per gallon
Latex•ite
®
2X CRACK FILLER is a specially formulated Acrylic Latex Rubber ... Vinyl Polymer Blend that provides extended
life & greater durability than ordinary cold pour formula crack fillers. Fass·Dri
TM
additive accelerates drying & curing time. For
blacktop cracks up to 1/2" wide.
• Premium filler for cracks up to 1/2" wide.
• Fortified with acrylic rubber for maximum flexibility and bond.
• FASS-DRI
TM
formula for faster set-up.
• Just clean crack, shake, snip open and squeeze into crack.
• Low VOC Formula.
Latex•ite
®
2X CRACK FILLER is a simple and clean process. Before applying the product, it is important to thoroughly clean out
the crack and remove any loose debris. Use a screwdriver and whisk broom. Rinsing the crack and allowing it to dry will give you
the best results.
Latex•ite
®
2X CRACK FILLER is easy to use. Remove all dirt, grass, old crack filler and debris from crack to be filled. Shake
well before using. Pre-mixed, DO NOT DILUTE. Cut tip to a size slightly smaller than the width for the crack to be repaired.
Squeeze/pour crack filler SLOWLY into crack. DO NOT OVERFILL. The 2X will self-level. Wipe clean any crack filler
residue from crack surface. (If you leave any on the outside of the crack it will track on a hot day!). Do not apply more than 1/4"
thick in any single application. If you have larger cracks you may first clean them, then fill with a backer rod to within 1/4" of
surface before applying Latex•ite
®
2X CRACK FILLER. Latex•ite
®
2X CRACK FILLER will dry to the touch within 30 minutes
and depending on weather, should be fully dry within 4-8 hours and ready to seal over. Use when outdoor and surface temp is 55
APPLICATION
SURFACE PREPARATION
FEATURES
PHYSICAL PROPERTIES & PERFORMANCE