Model Vehicle User Manual

LAN IER – 1/3
rd
Scale Laser 200 ARF -INSTRU CTIONS
© 2002 Lanier R/CPage-2
BUILDING INSTRUCTIONS
Beforestarting to build this kit, we urge you to read
through these instructions thoroughly. They contain
som e im portant building sequences as w ell as
instructions and warnings concerning the assem bly
and use of the m odel.
BUILDING SU PPLIES NEEDED
H obby knife w/ #11 blade
Medium Zap CA
30 Minute Z-poxy
Wire cutters
Pliers
Drill with bits: 1/32”, 1/16”, 1/8”, 5/32”, ¼”
See the list at the end of the instru ction book for a
list of additional R/C equipm ent you w ill need to
com p lete the 1/3
rd
L aser.
1.
L ocate (10) hinge points.
2. U se the picture as a guide to find the (5) holes in
each aileron and each side of the wing. Test fit a
hinge in each hole.
3. P ut a sm all drop of oil on each hinge, then use 30
minute epoxy on each hinge and hole. Press the
ailerons in place, leaving a 1/32” gap at the hinge
line, then wipe off any excess epoxy off with
alcohol and a paper tow el.
4. A t the two locations on the wing, rem ove the
covering from the hole to install your aileron
servo.
5. M ark the location of the aileron servo plate rails
on the inside of the plyw ood servo plate (aprox.
3/8”). R em ove the covering from the hole for
the serv o arm.
6. P osition your aileron servos and the hardw ood
blocks on the plates and mark the position.
7. G lue the blocks in place on the plates with 30
minute epoxy.
8. W hen cured, replace the servo and drill 1/32”
pilot holes for the servo screw s included with the