Installation Manual

■ Turn off the power of “SC Rover”.

■ Open the lid on the back of the main unit and switch the switch in the yellow frame to "Int".

■ Turn on the power of “SC Rover” main unit with a battery or an external power supply.

*BATT Lump : Green when using batteries, red when using external power supply

■ After turning on the power, “SC Rover” starts in the setting mode. (It takes a few minutes to start

up.)

GNSS lamp is off, WiFi lamp is on, and BT lamp is on, and you can access it by the Settings app.

"SC Rover“ : Setting preparation (Set to setting mode

）