User Manual
Table Of Contents
- 15-0421 - Exhibit Cover.pdf
- Zenith User Guide 98-1723.pdf
- Gridstream Enhanced Cellular Overview
- Setting Up Command Center
- Meter Ordering and Customization
- Deploying Endpoints
- Managing Endpoints
- Scheduled Demand Reset
- Specifications
Draft
Chapter 5 - Managing Endpoints Landis+Gyr
50 98-1723 Rev AB User Guide
General Tab
Figure 5 - 16. General Tab
The General Tab displays the following information:
•Switch State. The switch state indicates whether the meter is connected or disconnected.
• Multiplier. N/A
• Demand Multiplier. N/A
• Meter Dial Digits/Kh. Displays the number of dials in the meter and the meter’s Kh.
• Initial/Latest kWh. Displays the original kWh of the endpoint and the latest reported kWh.
• Module Firmware Version. Displays the current firmware version of the endpoint/module.
• Meter Firmware Version. Displays the current firmware version of the meter.
• ZigBee Firmware Version. Displays the current Zigbee firmware version.
• DCW Version. Displays the current DCW version.
• Initial Programming. Displays the original endpoint programming date.
• Last Programming. Displays the most recent programming date.
• Meter Program ID. Displays the Meter Program ID for all electric meters.
•Last Good Packet. Displays the date and time the last good packet was received.
• Pending Firmware Version. Shows the pending firmware version when a firmware
download is in progress.