User Manual

Draft
Landis+Gyr Chapter 1 - Gridstream Enhanced Cellular Overview
User Guide 98-1723 Rev AB 13
FCC and Industry Canada Compliance
FCC Class B
This device complies with Part 15 of the FCC rules. Operation is subject to the following two condi-
tions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including inte
rference that may cause
undesired operation.
This
equipment has been tested and found to comply with the limits for a Class B digital device, pur-
suant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the Instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television re-
ception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
• Reorient or relocate the
receiving antenna.
• Inc
rease the separation between the equipment and receiver
.
• Co
nsult Landis+Gyr or an experienced radio technician for help
U WARNING: Changes or modifications to this device not expressly approved by Landis+Gyr
could void the user’s authority to operate the equipment.
RF Exposure
This equipment complies with FCC and ISED radiation exposure limits set forth for an
uncontrolled environ-ment. This equipment should be installed and operated with minimum
distance 20cm between the radiator and your body. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.
Cet équip
ement est conforme aux limites FCC et ISED d'exposition aux radiations définies pour un
envi-ronnement non contrôlé. Cet équipement doit être installé et utilisé à une distance minimale de
20cm entre le radiateur et votre corps. Cet émetteur ne doit pas être co-implantés ou exploités en
con-jonction avec une autre antenne ou émetteur.
Industry Canada
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a
type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce
potential radio interference to other users, the antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful com-
munication.