User's Manual

Section 4, Page 4 ©09/2002, CATTRON-THEIMEG
™
Corrective maintenance.
Corrective maintenance for the Toggle Controller is restricted to replacing the Battery Pack, Address
Code Plug and, when installed, Side Lever(s) and External Antenna. Refer to the Replacement
Procedures below when removing and replacing items. Having replaced an item, and before placing
the Toggle Controller into operational service, carry out a Functional Check as follows:
Functional Check.
1. Set the controller’s Power ON/OFF Switch to ‘ON’. Observe that the
TRANSMIT/LOW BATTERY LED momentarily flashes yellow and two quick ‘beeps’
are heard.
2. Operate a non-motion function such as a horn or light on the target equipment using
the appropriate toggle switch and observe the TRANSMIT/LOW BATTERY LED
which should flash green.
3. Set the controller’s Power ON/OFF Switch to ‘OFF’.
4. Operate the controller in Switch Diagnostic Mode (refer to Section 3 for procedure),
insuring all toggle, pushbutton, and side paddle function switches are fully operational.
Replacement Items.
Replacement items and accessories for your controller may be ordered direct from CATTRON-
THEIMEG
™
. To order replacement items, refer to Section 5 of this manual for details and part
numbers.
Replacement Procedures.
Battery Pack Replacement.
To replace the battery pack, proceed as follows:
1. Set the controller’s Power ON/OFF Switch to ‘OFF’.
2. Referring to Figure 4-1 opposite, unlatch the battery door catch, open the battery door
and lift the battery pack out of the tray.
3. Install a fresh or fully charged battery pack in the unit, making sure the contacts on the
underside of the battery pack locate with their corresponding pick-up contacts in the
battery tray.
4. Close the battery door and secure by latching the battery door catch.
5. Carry out a Functional Check on the controller – refer to page 4 of this Section for
details.