User's Manual

™

Section 3, Page 5

General Operating Procedure, continued.

5. Place a convenient and comfortable part of the operator's hand on the PUSH TO OPERATE

BAR on top of the controller. This switch must be depressed and maintained before and when

any motor or motion command is initiated.

WARNING:

NEVER DISABLE THE PUSH TO OPERATE (PTO) BAR SWITCH ON YOUR

REMOTE CONTROLLER. FAILURE TO COMPLY WITH THIS WARNING

MAY RESULT IN DAMAGE TO EQUIPMENT, SERIOUS INJURY, OR

DEATH.

6. Operate the motion control toggle switches as required, remembering that the toggles must be

pulled upward for all REVERSE and UP motions and pushed down for all FORWARD and

DOWN motions. A speed increase is obtained by selecting different, appropriately marked

toggle switches. Compass direction labels (N, S, E, & W) may be engraved next to the

appropriate switches.

7. While commanding a motion with a switch, release the PUSH TO OPERATE BAR without

centering the toggle switch. The motion must stop - if this does not happen, set the controller’s

Power ON/OFF Switch to ‘OFF’ and notify your supervisor immediately.