Install Instructions

LAARS Heating Systems
Page 36
Air Vent
A device used to purge air from the Circuit. Should be
located at the highest point in the Circuit.
Branch
The section(s) of supply and return piping, including
the heat distribution units connected directly to the
trunk. Also referred to as a “zone”.
By-Pass
A section of pipe (including an adjustable valve) that
diverts part of the water ow from undersized piping
to the boiler. Adjusted to maintain minimum ow
requirement (GPM) through the boiler.
Circuit
Entire water circulation piping, beginning and ending
at the boiler (Series Loop System).
Expansion Tank (Compression Tank)
Installed in the circuit to accommodate excess water
produced by heat expansion.
Diaphragm Expansion Tank
Used instead of Expansion Tank (Compression Tank).
Internal bladder separates air and water.
Heat Distribution Units
Transfers heat from the water supplied by the boiler
to the area to be heated through the use of baseboard,
convector, radiator, nned tube. Also known as
“radiation”.
Isolation Valve
Used to isolate the boiler from the circuit. It minimizes
the amount of water drained from the system.
Primary-Secondary Piping
Two or more interconnecting circulating loops,
each with its own pump. Primary =System Circuit;
Secondary=Boiler Circuit.
Reverse-Return Piping
Balanced, equal ow (rst in, last out) piping. Utilized
with multiple boilers and/or radiation. Applied with
single system pumps, or primary-secondary pump.
System Purge Valve
A device used to purge air from the circuit. Should be
located as close as possible to the cold water feed, but
not immediately after the cold water feed.
Temperature Controllers
The primary temperature controller maintains all
normal heating operations.
A secondary, mechanical high-limit aquastat
provides safe shutdown, should the primary
controller fail.
Trunk
The section of piping which connects the boiler return
and supply with the branch(es). Also known as a
“main” or “header”. Should be same size as boiler
inlet/outlet connections.
Zone Pump
Circulators installed in branch piping that divert
hot water coming from the boiler into various areas
(zones) of a building.
Zone Valve
Diverts hot water from the boiler into various areas
(zones) of a building.
10A Glossary of Terms
SECTION 10. Replacement Parts