Installation Guide

314-158 Specifications

With suction cup:

1.8“ W x 3.5” H x 0.9”D

Without suction cup:

1.8“ W x 3.1” D x 0.5”D

Battery: 1.5V LR1130 button cell

Instructions: Remove the Insulation Tab from the Battery Compartment to start your

thermometer.

Note: there is no Instruction Manual. Directions are on the package.

Mounting location for accurate measurements: Choose a location that is not

subject to direct weather elements. An ideal location is out of direct sun, on the North

side of a building or in a shady spot.

Mounting on window or smooth surface:

1. Mount the suction cup to the thermometer. For outdoor use, mount the suction cups

to the front side. For indoor use, mount the suction cups to the backside.

2. Next, thoroughly clean the glass window or any other smooth surface.

3. After the area is completely clean, press on back of Suction Cup to the window..

Replace the Coin Cell Battery

1. Use a coin to turn the battery cover to the left to remove it.

2. Pull back the metal pin and gently remove the battery.

3. Insert a fresh LR1130 button cell battery with the + side up and snap into place.

4. Replace the battery cover and use the coin to turn it to the right to lock.

(Add Warning and Button Cell icons)

WARNING

1. This product contains a button battery.

2. If swallowed, it could cause severe injury or death in just 2 hours.

3. Seek medical attention immediately.

WARNING: KEEP BATTERIES OUT OF REACH OF CHILDREN

1. Swallowing may lead to serious injury in as little as 2 hours or death, due to

chemical burns and potential perforation of the esophagus.

2. If you suspect your child has swallowed or inserted a button battery, immediately

seek urgent medical

assistance.

PAGE 1
314-158 Specifications With suction cup: 1.8“ W x 3.5” H x 0.9”D Without suction cup: 1.8“ W x 3.1” D x 0.5”D Battery: 1.5V LR1130 button cell Instructions: Remove the Insulation Tab from the Battery Compartment to start your thermometer. Note: there is no Instruction Manual. Directions are on the package. Mounting location for accurate measurements: Choose a location that is not subject to direct weather elements. An ideal location is out of direct sun, on the North side of a building or in a shady spot.
PAGE 2
3. Examine devices and make sure the battery compartment is correctly secured, e.g. that the screw or other mechanical fastener is tightened. 4. Do not use if compartment is not secure. 5. Dispose of used button batteries immediately and safely. 6. Flat batteries can still be dangerous. 8. Tell others about the risk associated with button batteries and how to keep their children safe.