User Guide

Factory Restart:

1. Remove all power (batteries and AC) from outdoor sensor and forecast station.

2. Press one of the buttons on the forecast station at least 20 times to clear all memory.

3. Verify that the forecast station is blank before proceeding (there are some painted lines that will not

disappear).

4. Leave both units without power for 15 minutes (very important).

5. Insert the AC power cord into the wall outlet then into the forecast station.

6. Insert fresh batteries into the outdoor sensor.

7. Press the TX button on the outdoor sensor to transmit RF signal.

8. Keep the outdoor sensor 5-10 feet from the forecast station.

9. When RF connection is established, the temperature will appear on the station. Allow the outdoor

sensor and forecast station to sit together for 15 minutes to establish a strong connection.

10. Do not press buttons for 15 minutes

We suggest name brand Alkaline batteries for indoor displays.

Use Alkaline or Lithium batteries in the outdoor sensors.

A minimum voltage of 1.48V for each battery is necessary for proper performance.

PAGE 1
Factory Restart: 1. Remove all power (batteries and AC) from outdoor sensor and forecast station. 2. Press one of the buttons on the forecast station at least 20 times to clear all memory. 3. Verify that the forecast station is blank before proceeding (there are some painted lines that will not disappear). 4. Leave both units without power for 15 minutes (very important). 5. Insert the AC power cord into the wall outlet then into the forecast station. 6. Insert fresh batteries into the outdoor sensor. 7.