Installation Guide

Connect and secure cable to interior assembly.
D
a
b
Connect cable.
Ensure tight cable connection.
Insert key and
turn 90° clockwise.
Secure exterior lever. Install interior lever. Secure interior lever.Install exterior lever.
The small bolt of the latch should not enter the strike
hole. If it enters the strike hole, reposition strike.
A B C D E
Tighten pre-
installed set
screw.
If latch is loose in the strike, adjust the strike tab so it
grips the latch bolt better when the door is closed.
tab
Lever handle
faces away
from the latch.
Close door, test latch operation and make adjustments as needed:
small bolt in
strike hole
small bolt NOT
in strike hole
J1 or J2
H
Lever handle
faces away
from the latch
and hole is on
the bottom.
1. Tighten pre-
installed set screw.
2. Turn key back to
vertical position
then remove it.
J1 or J2
H
K
Route cable through clips.
a
Install interior assembly
while holding the exterior
assembly. Make sure the
spindle fully engages with
the interior assembly.
b
Secure interior assembly
with mounting screws.
K
Q (2x)
Connect 9V battery. Secure battery into interior assembly.Remove interior cover.
A B C
L
Hold exterior assembly.
This step is necessary
to access the set screw on
the exterior lever.
M
Red side must face left.
Installing the security
set screw will lock
the interior cover and
prevent easy access
to the battery and
Program button.
R
If you installed the
security screw in step 3C,
you will need to remove
it to install the battery.
TIP: You may need to jiggle
the handle while pushing to
ensure it is fully engaged.
68221
Install exterior keypad. OPTIONAL: Install security set screw.
Install interior assembly and secure with mounting screws.
A C
E
cable goes
under latch
actual
size
Q
Ensure both interior and
exterior assemblies are
parallel to edge of door
before securing.
R
Interior assembly
Note:
Tighten screws evenly
and do not overtighten .
CAUTION:
Do not use
power tools
Install spindle.
B
rounded edge
faces latch
latch
F
2 / 4
G
3
4
Install the exterior keypad, spindle, and interior assembly
5
6
Install levers
Test latch operation
Install battery
Make sure to
keep your door
open until you
have programmed
a user code.