68561-001 Fy Re vol = Parts In the box ZWave® Plus Thickset i CONNECT Latch Interior Assembly Exterior Touchscreen TEHAMHBURERN MICROELECTRONIC BEARABLY “Brig not included If knead Installation and User Guide inl x Fasteners Strike Keys 3802 46780 pm ad Required tools fg Lf noon pms s Pm communicant =r Thickset w Pea p= Ruler Phillips head screwdriver Technical Support : Ad Mount Smart Rotarian Tots dyeing on plateau) 18668636584 Ret Sa Jee assess po 4ot| 6a08 wwwkwikset.
H Install the exterior touchscreen oy # | Whats the diameter of the hole in the door? © install exterior touchscreen and mounting plate. Diameter is 21/8" Diameter is (54mm) © Gs mm) 218" nr 54mm 38mm “D* Is not needed for installation. Discard “TF, “DB Is required for installation, Install “D" on *F". Route cable through “center hole, then push cable Into bottom hole. E Insert key and Ld : test latch, if latch does not extend or retract smoothly, # | Locate screws for step 3C and keep them within reach.
a Add the lock to your smart home system #4 | initiate the process to add | the lock to your system at your smart home controller. When prorated by your smart home system to add the © lock. press button “A” on the lack interior ane time. The veld LED will eliminate when the lock enters Add Mode. successful, rename the lock ly our system Gt applicable). Refer to your smart home system Instructions for EB successful follow your system's Instructions to ions information.
Reference Guide Smart Code at a Glance Re-key the lock (if needed) Exterior Interior (cover removed) & IMPORTANT: Re-key the lock & Reinstall battery pack. Remove battery pack forthwith your Back before re-keying. existing key. See the panel supplied Smart Key Re-key Instructions Touchscreen Button “A” Button “8” for more Information.
