Manualshelf

Owner's Manual

ManualsBrandsKwikool ManualsServer Room Precision A/C ControlKwiKool 17,700 BTU 115V Commercial Water Cooled Portable Air Conditioner with Built-In Thermostat and Electronic Controls
12345678910
Page 7
ON/OFF Button - Pressing this button on your control panel engages or shuts
down your KwiKool system. All settings selected are stored in the microprocessor
board even if the power is lost including the ON/OFF selection. Refer to the
Troubleshooting Guide section of this manual if your KwiKool is alerting an alarm
after selecting ON.
MODE Button - Depressing the MODE button selects your choice of operations.
Cool, for cooling with compressor operation. “Cool” will flash when the compres-
sor is running. “Cool“ will not flash when the room temperature is equal to or lower
than the set temperature or the system is timing out. Fan, for air circulation without
compressor operation.
F/C - Selects the way that room temperature and set point are displayed on the
control panel. Choices are Fahrenheit or Celsius. F is the factory default. This
indicator will flash when the system is in “time out” to prevent compressor short
cycling.
1.
2.
3.
Single Speed Models - KWIB 2411, KWIB6023, KWIB6043, **KWIB12023,
**KWIB12043. On the single speed models, pressing the fan key cycles the
supply air fan between auto fan and fan on. When the system is in auto fan,
the supply air fan only operates when the compressor is running. When the fan
is set to on, the fan runs continuously as long as the unit is in the ON position.
The fan speed window will be blank on these models.
Three Speed Models – (All other models NOT listed above.) The supply air fan
control button has several functions. First pressing the fan key will cycle
through the fan speeds. Each press cycles from low, med, high, and
multispeed. Multispeed will display all three speeds and flash only the speed
currently in use. The fan speed is automatically adjusted based on demand.
The second function is to change from auto fan to fan (constant fan). To
change this function, press and hold the fan key until the indicator changes
from fan (constant fan) to auto fan. When in FAN MODE, auto fan is not
available. If the unit was set to auto fan before changing the mode to fan, auto
fan will return when the unit is set back to COOL. Factory default is fan
(constant fan) and is the best choice for electronic equipment.
**KWIB12023 and KWIB12043 - These models are 2 stage systems and have
a fan speed for each stage. This feature is not user settable. This system
always starts in first stage fan speed (low) in COOL or FAN MODE, second
stage fan speed (high) only operates in COOL MODE when the second stage
compressor is running.
a.
Up (+) and Down (-) Arrow Buttons - Raises or lowers the desired set tempera-
ture. When changing the set point, pressing the + or – key, the word SET will
appear on the display and the current set point flashes ON and OFF. The value of
the set point is changed 1 degree each time the + or – is pressed. The adjusted set
point flashes on and off 12 times after the last change and then returns to display
the room temperature.
b.
c.
5.
Fan - Pressing the fan button has different operations depending on the model.
4.