Installation Guide

INSTALLATION SHEET
CH3117
1.
2.
START FROM HERE
▪
▪
▪
▪
▪
▪
Make sure power is completely off at the fuse box.
Have your fixture installed by a qualified licensed
electrician
Prepare everything in clear area.
Wear gloves at all times during this installation.
Read instructions carefully before you start assembly.
Keep this instruction sheet for future reference.
Technical Support: 1-855-855-8926
Please Note:
• All Kuzco LED fixtures come with pre-wired LED
module(s).
• Unless instructed to do so, please do not touch any part
of the LED module(s) as any unnecessary contact with the
module could cause permanent damage.
• For dimming, an ELV (Electronic Low Voltage) dimmer is
required.
Ceiling LED pendants.
3.
3b.
4a.
3a.
2a.
2b.
2c.
2e.
2d.
You have now completed the installation of your fixture,
enjoy.
4.
Determine hanging height of fixture by securing rods (2c)
to swivel (2d) in canopy (2a) and pendant body (2e).
LED Engines are built in. Push the glass (4a) up to the LED
engines (4b) and thread turning clockwise.
5.
4b.
You are now ready to mount the canopy to the mounting plate
first connect all wires correctly L live wire (white to white) N
neutral wire (black to black) and G ground (green to green)
with provided marrets from the hardware package (3a). Align
the threaded scews hanging downward from the mounting
plate to the holes inside the canopy. Push the canopy up
towards the ceiling so the two scews point through the hole in
the canopy. You can then screw on the decorative nut (3b)
onto the threaded bar pointing through the canopy to securely
install the canopy to the mounting plate.
Remove the fixture from its original packaging. Remove the
canopy mounting bar from within the canopy by removing the
decorative nuts. Secure the mount plate (2b) (with canopy
screws facing downward) to the junction box.
L
N
19054 28th Avenue Surrey, BC Canada V3Z 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W: kuzcolighting.com
20191113