Installation & Assembly

Parts list
Part1
TOT-A
Part5
Installation Instructions
nail
connector
base support
steel tube
steel tube
rope
strap
Part6
Part7
Part8
Part9
Part10
foot
foot plug
plug
1
2
3
Step 1: First take out the two rows of steel pipes
as picture, rotate them clockwise as shown in
the picture to assemble until they are tight, and
then insert the screen according to the reserved
channel.
Step 2: Take out another two rows of steel pipes as
picture, tighten them in the same way, and fix the
four rows of steel pipes that have been installed
through four connectors.
please use equipped ground nails to maintain the stability
of the screen when outdoor use.
In severe weather, such as strong winds of level 3, please
move it to indoor.
Please be careful when installing to avoid cutting your
fingers.
WARNING
⚠
⚠
⚠
⚠
Step 3: The remaining two steel pipes need to be installed with two feet each, and then the
floor support and the vertical steel pipe are connected by a T-shaped connector.
Step 4: Through the holes reserved on the screen, fasten a thin strap around the vertical steel
tube until the screen becomes flat. Tie one end of the rope to the ring hole at the top of the
screen, connect the other end to the nail, and insert it into the grass.
Part11
carry bag
TOT-C
TOT-E
A
B
A
B
TOT-B
TOT-D
steel tube
steel tube
TOT-A1 TOT-A2 TOT-A3 TOT-A4
TOT-B1 TOT-B2 TOT-B3 TOT-B4
TOT-C1
TOT-C2
TOT-C3
TOT-D1
TOT-D2
TOT-D3
TOT-E TOT-E
4 pcs
1 set
1 set
1 set
1 set
1 pc
2 pcs
4 set
2 pcs
6 pcs
4 pcs
4 pcs
2 pcs