OPERATOR'S MANUAL

71REGULAR CHECKS AND MAINTENANCE WORK
BReplacing Engine Oil Filter Cartridge
(First Engine Oil Filter Change after 50
Service Hours)
1. Replace the oil filter cartridge at the same time as
doing the engine oil change.
2. Remove the cartridge with the supplied filter wrench.
3. Oil the O-ring of the new oil filter cartridge lightly. Then
tighten the oil filter cartridge by hand.
4. Fill engine oil to the specified level.
5. Let the engine run for approx. 5 min. and make sure
that the engine oil indicator lamp does not light up.
Then stop the engine and remove the key.
6. The engine oil level is reduced by the amount of the
filter capacity after the engine is started. It is usually
necessary to add oil.
A Always check the oil level after having exchanged the
filter.
EVERY 500 SERVICE HOURS
Do all 50, 100 and 250 hour servicing at the same time.
BDrive unit Oil Change(First Oil Change of
the 50 hours)
To avoid personal injury or death:
A Lower all attachments to the ground, stop the
engine and remove the key before undertaking
the oil change.
1. Rotate the track so that the drain plug of the drive unit
is in the bottom position.
2. Remove the drain plug to let the oil run out. Screw in
and tighten the drain plug again and fill with gear oil
through the oil check port.
3. Fill oil until it overflows out of the oil check port.
Oil change
- first oil change after 50 hrs
- then every 500 hrs
- or at least once a year
4. Use prescribed gear oil SAE 90.
(1) Oil filter cartridge
(1) Oil check port
(2) Drain plug
(3) Oil filling port
Gear oil volume approx. 0.6 L